1990 Ranger won't crank back up.

[jacobs_27]

I may not have completely covered the TFI with the paste. Iust ran a bead all the way across it. Too funny Shortbed...unfortunately I ate the crap they wanted, so I got a bad lunch and a bad deal when I came out. I'll have to wait till it's towed home again.

 

[smokey]

If you ran a bead across the plate that should be fine. It smashes out and you tighten the TFI down

 

[jacobs_27]

Ok...I got my truck home today and pulled the fuse box back out and pulled the EEC relay under the fuse box back out. It still looks new, but I have noticed that the wiring plug that it plugs into has bare wires that don't look to good,
along with the other 2 relays beside it. Where do I get new plugs to plug the relay into. I need to be able to strip back the wires and re-do them I think.

 

[smokey]

Normally you can disassmebly the plugs and put new ends on. not sure if they even make those plugs ends amymore.

 

[jacobs_27]

Thanks...I'll give it a shot. I sent my wife to get a new dist cap and rotor also. Looked worse than I remembered.