Join Our Ford Truck Forum Today

Document your Ford truck project here and inspire others! Login/Register to view the site with fewer ads.

NP 435 shifter ?

How close is you alls shifters to the dash ? I'm going to pull this out,
bend it , paint it and reinstall it.
006-2.jpg
 

lostinfords

New Jersey Chapter member
227
17
Jersey shore
you have one of them too!..:) I changed the trans in my supercab around 8 yrs ago and wound up w/ the 'knuckle buster' trans also, told myself I was going to modify it also but it was not being used that much back then and I just used low gear w/ an open hand, pushing it fwd. instead of a closed hand over the top...adaption!!...heck who am I kidding, adapted because I forgot about and never got to change it, but it brings comfort to see another w/ the same 'issue'...I did one handle yrs ago while it was still in the truck, just heated it w/ a torch bent it to where I needed it and repainted it, that one would hit the seat when you went to go into reverse, thus not allowing it to fully engage
 

DNFXDLI

The Token Canadian
Staff member
49,083
1,089
The Great White North
When it comes to mudding, I'd take an automatic over a standard anyday...

I gotta say that I agree with you Charles...for me it's an automatic over any standard...and yes, before the flaming starts, I've driven lots of standards....hehehehehe.
And Mark....one of the trucks I had with that transmission was pretty much the same as your picture.
 
I've never owned a 4WD with an automatic [confused]

I'm not much of one to argue, ( my sister got all that trait, she's an attorney)
Just about everything has good points and bad points.
And I heated it up and bent it a little while ago. Didn't have any paint on hand tho.
 

DNFXDLI

The Token Canadian
Staff member
49,083
1,089
The Great White North
I've never owned a 4WD with an automatic [confused]

I'm not much of one to argue, ( my sister got all that trait, she's an attorney)
Just about everything has good points and bad points.
And I heated it up and bent it a little while ago. Didn't have any paint on hand tho.

No so...all I have is good points :D
 

Ford Truck Articles

Top