misfire?

[89frankenford]

ok so my check engine light has been on for about 2 weeks now and i just got around to see what the codes were earlier today. ive got the codes (24, 67, 84) the 24 is the ACT sensor code the 67 is the nuetral safety switch code and the 84 is the egr control solenoid. i replaced the egr solenoid with one i gto from a junkyard van about a month and a half ago. when i was trying to figure wout my trailer wire demons tonight (see the trailer thread) i was right next to my exhaust. now when it was idling it ran great at the beginning but once the truck warmed up it had a random misfire. i did notice that my truck does run very efficiently (well i think it is because i have water condensating in the exhaust) sooo would all this be tied into each other?

 

[89frankenford]

nobody? nothing at all?

 

[surewhynot]

I wish I could help, but I know nothing about computer control systems.

I'll give it a bump for you though.

 

[radialarm]

http://www.fordfuelinjection.com/
This place has a lot of good info!!!
The 67 NSS is most likely your fault for not pushing in the clutch during the test!!!

 

[89frankenford]

yeah i know about the 67 code. i get it any time i check for codes. ive been fishing through FFI a bit here and there. i think im going to start by replacing my ACT sensor first

 

[Skandocious]

Tough to say Travis... I'd address the problems that the codes specify and then go from there.