i bought this gauge set, and am ready to install it. i was looking over the installation manual, and i don't get part of it.
here's the manual: http://www.iequus.com/downloads/manuals/93-0010.revB.pdf
scroll to page 2 and look at the graphic of the install diagram on the right.
i put the tubing through the compression sleeve, then the sleeve inside the nut. when i screw all that onto the gauge port i can still pull the tubing right out the back. what am i doing wrong? doesn't exactly seem "oil-tight"
here's the manual: http://www.iequus.com/downloads/manuals/93-0010.revB.pdf
scroll to page 2 and look at the graphic of the install diagram on the right.
i put the tubing through the compression sleeve, then the sleeve inside the nut. when i screw all that onto the gauge port i can still pull the tubing right out the back. what am i doing wrong? doesn't exactly seem "oil-tight"