1970Custom
They call me Spuds
So now that the weather has improved enough for me to get out and do some work on getting my stuff up and running before I leave for Sacramento come June I've run into a bit of a snag.
This past fall I swapped an Offy intake, Holley carb, and a hooker header in place of the oh so wonderful stock pieces.
I've got it running quite well and am now at the point of getting the exhaust routed and I'm not sure what to do about it. The first three cylinders
exit the collector slightly angled down and towards the drivers side as well as is directly in front of the cross member.
The rear three exit just forward and above the cross member but also angle down and towards the driver's side.
Anybody thats done the swap could you please tell/show what you did to complete the exhaust.
Thanks,
Eric
This past fall I swapped an Offy intake, Holley carb, and a hooker header in place of the oh so wonderful stock pieces.
I've got it running quite well and am now at the point of getting the exhaust routed and I'm not sure what to do about it. The first three cylinders
exit the collector slightly angled down and towards the drivers side as well as is directly in front of the cross member.
The rear three exit just forward and above the cross member but also angle down and towards the driver's side.
Anybody thats done the swap could you please tell/show what you did to complete the exhaust.
Thanks,
Eric