never would have thought of a cam from an RV. wat is the difference between speed density and mass air flow EFI? i know wat a mass airflow sensor is but then im lost.

Thinking of doing a mild cam swap to a 92' bronco with a 5.0 my first question is can i just by a cam and lifter kit and install it with out having to change anything else such as pushrods springs ect. i will do that but down the road its a slow process. which leads me to my next question i...

ill do that appreciate everything. cruise dont work anyways forgot about that

yes everything everything else works too. no problems otherwise

Have a 92 bronco with a 5.0 bought it and the speedometer the odometer dont work, and the shift point are also off. i swapped the Vehichle speed sensor out which was located on the rear end. also checked the fuses but still have not fixed the problem. i dont know where else to look except maybe...

already changed the filter. the pump in the tank was replaced just a few weeks ago went bad. ive replaced both pumps, filter, regulator still cant figure it out. havent found a vacuum leak yet. sometimes when i turn the key on the pump runs continuously so i replaced the regulator and it runs...

ya same effect could the Computer be opening the injectors wrong or holdin them open maybe.

no codes regarding the issue only one was a AC code

it turns over but wont start. feathering the gas pedal almost makes it crank but not always. on an EFI the pedal should not make a difference like a carbed motor right?

Have A F350 1989 with a 460. sometimes it cranks sometimes it wont. smells like its flooding out. my fuel pump runs too long when it doesnt crank. its a new pump. if i hold the gas pedal down sometimes it starts. almost like it isnt getting enough air. i think the fuel regulator may be sticking...

gonna replace the water pump tomorrow. while im at it i wanna know about adjusting the cam timing. replaced the gears and chain not to long ago and the gear is adjustable in 2* intervals advanced or retarded up to 4* eiter way. wat difference would it make either way and how much would be good...

any recomendations on products? wats durabak never heard of it?

so far so good. now i can get back to body work. shes in bad need of a paint job. thinking of just going over the red with red primer and white with a grey till i get the money to paint. working progress. any opinion on the duplicolor truck armor for the bed?

had a loose wire on the coil. it was the +battery wire. it started up now wat i wanna know is would that effect my injectors or did it just happen to crank? my problem is not constant it was intermittent. so am i gonna get stranded at walmart or could this be my solution? any ideas?

there is good spark all the way from the streetfire coil through my dizzy to the plugs. needs plugs and wires im sure but am gonna wait till i get her running first. the eec tested good in all areas today at autozone. they told me it didnt effect the injectors just the spark after the dizzy...