Straightened the bumper... Sorta

[Skandocious]

Finally pulled off the bumper and attempted to straighten in out. Got the passenger side straight as an arrow, but had a real tough time with the driver side. Had to remount and dismount the bumper 4 or 5 times to check alignment, got better and better but just couldn't get it all the way.

I bet the brackets that are attached to the bumper which were nearly impossible to bend back since the bumper doesn't weigh very much so I couldn't get any leverage. So instead I just bent the brackets on the truck in the opposite direction. Two crooked brackets = One straight bumper (sorta) Also snugged the bumper up towards the grill as far as I could. "Prove it!!" Okay

Had to cover the license plate because the reflective material was screwing with the flash:

 

[Skandocious]

Whoops, here's what it looked like before:

 

[lil_dq]

now the poor thing looks like it suffered a stroke with just the one side all saggin and stuff! ROTFLMAO

 

[lil_dq]

at least before it just looked pissed off! HAHA

 

[godblessmud]

The reflective-er your liscence plates the better! cover it in saran wrap so the red-light camera cant get a peek at it!

 

[TheRoadVirus]

That's too bad you got one side nailed and not the other. Still looks better than before, though.

 

[tomtoc]

OK, you win - still haven't touched mine. good work

 

[lil_dq]

Yeah it looks good. I know mine was a PITA after the body lift to re-align!

 

[89frankenford]

yeah mine was wicked hard to do, oh wait mine isn't sagging at all!

 

[TheRoadVirus]

Mine either . Although my rear bumper is pushed in about a half inch from a prior minor rear-ending I assume. I'll have to replace the brackets at some point.

 

[msb71]

It does look better than before ,but it still needs work to make it better.

 

[Lost]

I have had my drop bumper on several trucks . Every on took some serious redo to fit nice and all were fords . Good job.

 

[Skandocious]

I have had my drop bumper on several trucks . Every on took some serious redo to fit nice and all were fords . Good job.

Yeah I might go down and get some washers today to space out the drive side. We'll see how that goes.

 

[O'Rattlecan]

looks better than it did before, Chris.

Ryan

 

[TheRoadVirus]

Just park your truck so you can only see the good side.

 

[Skandocious]

Got it totally straighted out now with some washers Check it out

 

[89frankenford]

nicely done chris!