again, trying to install my autometer gauges and i finally found the oil pressure sender. it's in the very back of the block, right in the center. i honestly have no idea how i am going to get to it.
anyone done this or have any tips on how to get to it?
driver's side, passenger's side - both have a lot in the way. i can barely touch it with my finger, much less get to it with a wrench. getting to it from underneath looks like it's out of the question too. my intake takes up all the room on top of it. i don't consider myself mechanical enough to start taking other parts off to get to it. i thought this project was going to be "take this out, put in a T and reinstall" - if that's not the case, it might be over my head.
i'm a horrible mechanic
anyone done this or have any tips on how to get to it?
driver's side, passenger's side - both have a lot in the way. i can barely touch it with my finger, much less get to it with a wrench. getting to it from underneath looks like it's out of the question too. my intake takes up all the room on top of it. i don't consider myself mechanical enough to start taking other parts off to get to it. i thought this project was going to be "take this out, put in a T and reinstall" - if that's not the case, it might be over my head.
i'm a horrible mechanic
