I know that place. I used to buy some of my books for SPSU in that bookstore in the same shopping center.Looks great. What would the same cost at Line-X?

This happened a few days after a new alternator installation, not sure why. Should be fun trying to get them out. 2 out of 3 are broken inside the head.:headbang:It also appears I have a fluid leak.I'm tempted to just pull the motor out, since the rear main seal, valve cover gaskets, and...

Thanks for the info Skan.

Skan, would you mind clarifying a few things about your exhaust for me?The 2-into-1 Magnaflow cat acting as your y-pipe, what size are the inlets and outlets? I'm guessing 2" and 2.5" out? I'm guessing the second cat is 3"?Are you using a flowmaster y-pipe or something similar to split off...

I don't see myself doing any crazy wheelin', so I think the TTB would serve me just fine. I mainly just want the 4 wheel drive for when I go hunting, and maybe some mild off-roading. The SAS also takes more time and money to install. I might consider it if I run across a good deal on a solid...

Here's a few pics of my dirty 2wd. The 215+k worn out front springs have sagged quite low, which I don't like. I have been thinking about what I want to do with this truck for a while.One option is some leveling coils or F250 coils.Another option is a full 4wd TTB swap. I found a near...

I have seen them on the Atlanta CL a few times, but they are either too far away or too beaten up. I'm willing to pay a little more for a nice set.

What about NPD, National Parts Depot? Any good?

Hi all,I'm looking for some new center caps for my truck. So far, these Ebay ones look like a decent choice.LMC Truck has them on page 83 of their 80-96 catalog.Are these the same? Any other places I should look? I figure it would be more from the dealer, didn't even look.Thanks.

Yes, I plan on replacing it. I'd rather not chance it.

The damaged hole in mine was not hollowed out, it was just missing a chunk. I think it would have became hollowed out had I kept driving on it.

How does it to compare to the pic I posted? Better/worse?

I think maybe he meant he's been 4wheeling like that after he replaced the U-joint? I hope so anyway.

True. It is definitely better than it was. I will probably replace the bad piece, but this was the first step in getting it ok to drive. I'm 2wd and I usually drive pretty mild, so I think it will be ok for now.

Yes, the u-joint was so loose it started to eat at the yoke. I was a little worried, but I put the u-joint in and it was firm. Still plenty of material left. Scary stuff though, I'm really glad I fixed this.