Does anybody know where I can get extension housing(tailshaft) housing gasket at? My truck is a manual btw.

ok I might do that then thanks!!!

ok thanks fellro I do believe I have a seal that fits this hopefully. Its just getting the seal out is going to be tricky it looks like.

I took my transfer case off and found out that this seal looks bad. The little spring fell off. I was wondering what this seal is called thanks.[/URL][/IMG]

Hey guys Id like to thank everyone on my other thread for the help on my tcase. Anyway got my tcase in and everything seems fine but I just noticed my clutch pedal does come back all the way im going to say half way then sorta stops then i just have to touch the clutch pedal then it come up all...

Like I said I can't get the housing down on it without it locking up the shaft seems like the shaft it sitting up higher I can't get it to go down any more.

Heres are some pictures of what I mean seems like my input shaft sits up to high but I replaced the roller bearings in it and made sure everything looked right.housing[/URL][/IMG]shaft[/URL][/IMG]Inside

Hey guys need a expert on the np 205 transfer case. I rebuilt my NP205 t-case myself and seems I ran into a slight problem. Anyway Im about done with it or so I thought. My question is I put my rear output shaft in my t-case and everything spins freely like its suppose too, however when i put...

thanks guys for the advice.

its a single cab long box so theres no carrier bearing. I do happen to have aggressive mud tires on it but they are in good shape and other ideas you guys can think of. Would you guys think if the previous owner didn't mark the driveshaft to reinstall it would cause a vibration?

I have a nasty vibration that starts at 45 mph and it doesn't stop. U-joints in the driveshaft look good and the weight is still on the driveshaft do you with the driveshaft needs rebalanced? Its so bad I can't put my hand on the 2wd and 4wd selector stick because its vibrating so much. My truck...

I just recently rebuilt my carb and I need advice on how to tune the idle mixture screws thanks guys.

Hey guys I need some help. My hot flow tube that goes from the choke to the engine has a crack in it I was wondering if any knows where I can find one thanks.[/URL][/IMG]

Does anybody have a set or know anybody thats selling a set of westcoast mirror? thanks

After all day I got her running. I replaced the ignition module, pickup coil in the distributor and then finally the ignition coil on top of the engine. Now it starts up ones you touch the key.