LEB Ben
Arrogant A-hole At-Large
Holy chit...I had no clue. So it's safe to say the $2600ish advertised cost isn't the actual cost then to make it a safe functional engine then huh?
Holy chit...I had no clue. So it's safe to say the $2600ish advertised cost isn't the actual cost then to make it a safe functional engine then huh?
Itll have a ton of power though wne its done. Burn out vids.
Good luck on the 434 build! I have Dan's efi specs somewhere in my files.
If you have that info, is there anything you can post on it please?
when do we get pics of said engine????
CHI 400(I think it's a 351C since the spacers are put in there) intake manifold where the efi ports will have to be drilled, but the bosses are already there for it. 3 feet of Dash-6 extruded fuel rail from Sullivan Performance, Aeromotive fuel press. reg., set of 42# injectors,
2003 Cobra throttle body and plenum from Sullivan Perf., 90mm Lightning Mass-air, An-6 fuel line, 3/8"/An-6 adapters, GP Sorenson sensors, Weiend carb spacer, GLS393 Walbro pump and Earls inline filter, A9L ecm, 89-93 Mustang harness, etc...
http://www.pricemotorsport.com/html/body_ap-34__intake_adapter_kit.html These are similar to his block off and spacer plates.
As you can see, it's really not all difficult, but it is spendy. I also should mention that the set-up originally was with a 460efi upper, but it was too tall. May not be such an issue in your truck? I'm going with a 434 using a standard aluminum 4150 carbed intake, and if and when I decide to go EFI, It's a matter of swapping the 4150 carb for the Sullivan plenum, and fabbing the injectors and fuel rails, though I don't think I have room in my Tbird. The high-rise manifold is so the plenum can clear the dist.
PS: I give Dan Lee full credit! He has been very helpful in giving me his R&D info and advice.
Hey Duncan are you thinking of doing EFI on your truck?
If so check this out.
http://www.affordable-fuel-injection.com/index.php?id=2&title=Fuel+Injection
If your gonna daily drive it I say go EFI duncan, but if its going to be a toy carb that baitch! and be done with it