I have a 1988 full size Bronco with 302 motor. It has been running fine but sometimes it will just quit running. It will crank right back up with no problem. Sometimes when it gets in a bind like an incline, it will sputter but when it does, I floor it and it goes right on.
Ok, I pulled the...
OK, great news. that dude is fixed!!! after replacing the key cylinder, sylinoid, and neutral safety switch, it was the acuator rod that was the problem. It was too far back. Slid it foreward and it works. thanks for yall's patience and help. God bless <>< delsmilieFordlogo smilieFordlogo
I have changed the ignition switch, the acuator rod is moving as it should. I took the sterring wheel off and checked all that. I am just high pi$$ed at this truck now. about ready to give it away. thanks for trying to help me. <>< del
ok, I got the new key cylinder in and it still will not start. I checked the sylinoid and it is good. I replaced the neutral safety switch. still no start, will not even try to turn over. can someone PLEASE help me out? I am about to lose my mind with this truck.:hammer: :hammer: someone...
ok, I got the new cylinderi andit is still kinda hard to turn just like it was before I replaced it. The truck will not start either. We were having to hold the gear shifter up to start, now it will not even start while I hold the gear shifter up. What else in there that would cause it to not...
I have a 1988 full size bronco. I cannot get the key switch out. I tried to push the little button under the switch with a small screw driver but nothing. I pulled the sterring wheel and still cannot get the switch out. Can anyone help me? What would cause it not to come out? thanks <>< del
No, it doesn't matter if the engine is hot or cold. It does it the most when we are pulling an incline or just in a strain. I am going to try to pull the codes. I am not very mechanically inclined but I am going to try. thanks ><>del
I have a 1988 bronco with a 302 motor. It runs good but when it is under a strain, it starts missing and cutting out. The red check engine light comes on but goes out. I changed the plugs but it still cuts out. any help? thanks ><> del
I have a 1995 F250 lariat. The tilt is broken, it will go up and down and not lock into place. How do i take the steering wheel off to get to the problem? thanks in advance. <>< del