Trying to re-install front sheet metal (51 f1) that PO removed as a unit and I needed to know the measurement distance between the eight and six cylinder rad support holes in the inner fender. I have / had to install the rad support first when installing the engine etc so now have to juggle it into place, and its hard to see. To further complicate things it turns out that this front end was never installed on this truck and yes I could lie on the cold concrete and measure the bottom rad supports holes but; (a) management would like a post from me, (b) the cook had me install a dish washer yesterday (sore) (c) and the weather is cold and damp so the arthritis is acting up today. Thanks.