Hi MarkI actually bought what was supposed to be the sump/oil pan 4x4 off Bronco Graveyard - but when it arrived here in Australia it was for a 2wd not a 4wd - have emailed Jeffs Bronco Graveyard to rectify the wrong part being sent but so far they have refused to reply… Dissapointed to say...

Hi Guys,Im chasing down an Oil Pan - Reverse Sump for my 4x4 1979 F100 with a 300 cu inch straight 6 cylinder…Can anyone help me locate one ASAP & I am in Australia…Thank you in Advance Gentleman:-))Paul www.thejourneyman.com.au

I read somewhere on Fordification.com/net that the engine mounts for a 78 model F100 4x4 with a 300 cu in cyl were a special type one off… at least thats how i read the post… so i may be onto the telephone & talk to as many F100 wreckers etc to find out the truth (but you would think Ford...

They look exactly the same (I should try to get a photo to the thread to make it easier) but my workshop manual diagram shows the brackets to be used are no's 5057-G & 5058-L as opposed to 6028 shown in your diagram - altho i suppose numbers can be changed etc I'm gonna go have another play...

I can't see an extension piece in the diagram to be honest - but I do have engine mounts 6038 (both sides) that bolt to the block & I seem to have the rail mounts (perch mounts) 6028 & 6029… (however as I said couple replies ago - mine a different numbers for some reason…

Thanks mate,The new F100 diagram shows pretty much what i suspected in moving the mounts I have forward to extra set of holes (gaining me about 80mm) of room but Im still short of about 40/50mm. I may have to try to re drill the face of rail these mounts & move the hole forward. I have tried...

Do you have another diagram showing F100 (not 250/350) 4x4 1979 brackets to fit the 300 cu in motor? as the farm is slightly different close to the crossmember… my workshop diagram shows the brackets to be used are no 5057-G & 5058-L which are different from the bracket numbers in your diagram...

Thanks for your replies guys…This engine is a straight 6cyl 300 cu in twiceblown351 & is going into a 4x4 79 mod shorty…Thanks for diagram DNFXDLI - I will check it against my workshop manual as well + numbers

Thanks for the welcome guys:-))

I'm assuming you mean extend them (the original engine mounts)…I was hoping there were factory made mounts that I didn't know about, but thanks for the reply guys!

G'day GuysI need your help on finding the right info on engine mounts…I have a 79 F100 4x4 down here in Australia & pulled out its crappy 4.1 lt crossflow & installing a fully rebuilt 300 cu in 6 cylinder into "Big Red"But the engine mounts won't fit the new motor & no one down here seems...

G'day & thanks for allowing me to join this site of Fanatics…I have an F100 1979 4x4 SWB & I intend to do a lot of travelling across Australia in in - hence the name The Journeyman I have a website & FB page of the same name if you want to check those out…BUT - I have a big problem to solve...