My Oklahoma Sate University broncsmilieFordlogo Love my truck

Another of my bronco's

These are my bronco's

Well thanks for taking the time to help me, Good night to you. smilieFordlogo

I think I just run a jumper from Self Test Input plug to negative battery term, but not completely sure, I know most females are mechanically challenged but I try to be informed enough to do simple repair to my truck.

Yes it is, but not all the time

I need help performing a self test on EEC on 351w

How do I self test my EEC for codes on a 1993 Bronco ?

While driving, I have no power while in over drive, but when I turn off OD, I have better acceleration but if I give it too much gas, it tries to bog down, not sure what is causing this.

I have 1993 full size bronco, 351w, and I just replaced the motor, the distributer is rusted stuck and I cannot losen it at all. The truck is running poorly and everyone has told me that the timing needs to be adjusted but I cant adjust the distributer. I have tried spraying stuff on it to losen...

I have 93 bronco 351w,it began idleing so rough that while at stop lights, I had to put it in neutral and rev up motor to prevent it from dying. It also slowly began losing power on acceleration and the more I try to accelerate the more it bogs down and sometimes back fires. I have replaced the...

Yes I mean an illustration, I have to replace the,( I am not sure of the part name), shift lever rod maybe,I have the steering wheel pulled apart and found the broken piece, maybe its called the shift tube, any way I sure would love to have a better diagram than what I have right now.

Does any one know where I might find an exploded diagram of a steering column?

Bronco owner 4 lifehere is one of mine, freshly painted for Oklahoma State University football....~~GO POKES~~~smilieFordlogo

Not as fond of this one though but it is a nice truck:)

do you know what the name of that part is?

Well thank you so much

1993 automatic

My 1993 ~~OSU~~ Bronco, just painted last Sept...

smilieFordlogo I broke the gear shifter handle on the column and I am not real sure how to replace it, I am guessing I will have to pull the steering wheel, I have done this before on a different Bronco to replace the actuator rod,but not too sure about this.