make sure you put everything in neutral(trans and transfer case) before shifting. and push on the brake (the shift motor has to have the brake pedal applied impulse before it allows complete shifts).
he GEM is supposed to be programmed before installation. one way to tell if the programming hasn't been performed, The interior lights blink!
BEEN THERE, DONE THAT. Had to do a lot of research before I figured that one out. Thought they were never going to quit flashing. If the programming
Is...
as far as the cannot detect cylinder#, look at the crankshaft position sensor on the front pulley. it will Read off of the "star" wheel that is attached to it. perhaps it isn't plugged in or a broken wire or damaged lower pulley.
stallingthe coolant temp reading -40 means that the coolant temp sensor is disconnected (or the pcm "thinks"it is)with that reading the pcm will make adjustments in timing, injector duty cycle in an attempt to "warm it up". Theres where your fuel is going. if you create a massive vacuum leak...