rambler
New Shoes......
OK,, finally got the rear driveshaft off, had to borrow a neighbors torch and heat up those 8 MM bolts to get it loose to take off.. and replaced the rear U-Joint, I bought a "better" one with a grease zerk on it, and bolted it all up, now I cannot seem to get my grease gun to squeeze between the yoke to hookup..
any ideas? I dont think I can just take the zerk off and try a 90 degree one ( I used the one it came with ) do they make special grease fittings?
dont want to have to replace this one again, nor take down that driveshaft, just to grease the U-Joint..
any ideas? I dont think I can just take the zerk off and try a 90 degree one ( I used the one it came with ) do they make special grease fittings?
dont want to have to replace this one again, nor take down that driveshaft, just to grease the U-Joint..