Oh yea..forgot that..Key On Engine Off flashed for egr opening not detected...but like I said,,those were replaced..

I'll probably end up taking the truck to a garage but I'll check here first... Motor is a 351W in a 95 150 When I punch the throttle quickly I get a lag and "stumble" before the revs come up. It does it all over the rpm range, not just idle. It is even more pronounced if I have let off the gas...

Very true Alvin, it could turn into a girly slap-fest real quick !

I have seen those lenses out on the street and they look pretty good. I was debating on getting them but did the Maquires resto kit. If you take your time and put out the elbow grease they come out looking like new. Just a tip: When working your way through the 4 sanding pads keep a little...

Anyone know how to clear the KOEO (key off-engine off) codes ? I disconnected the battery for a while to no avail.

If it's an automatic their could be an extension rod welded somewhere into the gear selector shaft that runs into the tranny. (they might even do that for a manual stick also but I have only installed a kit on an auto),,,If that's the case, you would need to either cut it out and reweld the...

If all else fails go to a Ford Parts dealer.. They will be sure to take 30 minutes and pull it up on the fische...then tell you "not currently available" or "discontinued"....but, then again, you might luck out...at least you will get the correct part #.

Don't forget the POSSIBILITY that he may be trying to sell it to get you your final share of monies and get you off his back.... He gets $$ from the potential new buyer, brings you the outstanding balance, gets the title and either just gives it to him or transfers it to him.

Any dealer is there for one thing, to make money. Personally, he's way too high on the price, but that's so he can "negotiate" a little and make the (clueless) buyer think they have gotten a decent deal, meanwhile he has only slightly cut into his profit margin. I would say "Nay" and get a...

Running a plastic body putty spreader under the tape would be the first step. I had great luck with 3m adhesive remover (spray can) for anything left.

I had one on my bronco. Prepped it, painted it body color on the top and flat black underneath. Seal the screws well to prevent rust and dab some on the screw heads to keep the screw caps from falling off. The troughs the screws are in hold water. Even when moving, unless you are out on the...

Currituck....the projection lines for this storm pretty much go over top of my house 'smiliedoh'

Appreciate the input. No pics yet, gearing up for "Irene" now.... and now I wish I had the tags current so I won't have to worry about high water :headbang:

Just found this site so I figure this may be the best place to ask.... I'm trying to figure a value/price to "maybe" let my 95 F-150 XLT 4x4 Centurian Crew Cab conversion go for.:( I just don't use it and haven't for quite some time so the thing just sits... Some facts on the truck are : 1...