Sent from my iPhone using Tapatalk

It’s been a while since I posted. Finally have some upholstery done on the ford!! The pictures are dark I will get some more later. Still have to coat the floor then order the factory rubber floor mats.Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

Had this little jewel roll into the shop today. Doing a ring and pinion swap for the rear diff. Nice shape runs good and sounds great!!Sent from my iPhone using Tapatalk

Just gave the Car a very need cleaning!! Looks good!!Sent from my iPhone using Tapatalk

Drove the ford tonight!! So far it’s doing great. All noises are gone and the the new shocks and tires made it ride like a new car!! I will get some pictures and a maybe a video of it tomorrow. Now all it needs is bath and some detailing. Next will be coating floors with the POR 15 and...

Hope to drive it later this week. I discovered that I didn’t have brake lights. Found the wires going to the switch off the master cylinder barely hanging on by one thread of wire. I ordered a new switch and wiring harness last night so I hope to see it here in a few days.Sent from my iPhone...

I had a little time to look into my transmission problems and have not found anything yet. All sensor readings I can see on an scan tool look normal. I triple checked fluid level. So I have made an appointment at the trans shop for a week or so from now. I know the owner really well and he said...

I decided to run the original caps and rings on the light green wheels for now. I will put the Cadillac hudcaps back on eventually. Thought it would be a nice change. The car had a bent wheel on it and we had he green set sitting loose and they were in better shape. I put a new set of Coker wide...

Got it back on the ground last night and ready to test drive.Sent from my iPhone using Tapatalk

Thanks I think it turned out great. It took a little time but was well worth it. I used Eastwood Rust Encapsulator and Eastwood chassis black. Both products are great and the finished product looks like it will last a long time.Sent from my iPhone using Tapatalk

Been a while since I posted in this thread. I ended up pulling the rear diff out of the ford to fix a noise and turned it into a small project. Decided to clean and paint the housing. Had the car apart almost 8 months. Just finished getting back together last night but the battery wasn’t up...

The funny thing about the stalling issues is that it doesn’t happen immediately when you stop. It will idle ok for about 10-30 seconds then you fell it bogg down and the rpm drop to the point it will stall. Put in neutral or 2nd goes away and idles fine. If you keep a little throttle applied the...

I have changed the fluid and filter. Maybe I should have used Mercon IV instead of the factory spec? I used versatrans fluid which is up to the factory specs.Sent from my iPhone using Tapatalk

I looked at the connector when I put the solenoid pack in last fall. It seemed ok I cleaned it and put dielectric grease on it and plugged it back in. I will check again and make sure nothing is rubbing on exhaust or anything around it. Solenoid pack did not fix the issues it happened again once...