Dusty, If the EGR is working properly couldn't I just replace the gasket with a pre-made one?

Looked at the gasket on two websites. Holes look about the same size. Where would I buy gasket material to make my own?

Got the TPS problem taken care of. Got a defective one from the parts store. After I put the new one in the CEL went off. Took it for a test drive and CEL came on less than a quarter mile from the house. Ran codes again and got a Code 33; EGR not opening properly. So I guess I am chasing...

Got the TPS problem taken care of. Got a defective one from the parts store. After I put the new one in the CEL went off. Took it for a test drive and CEL came on less than a quarter mile from the house. Ran codes again and got a Code 33; EGR not opening properly. So I guess I am chasing...

I replaced the TPS this afternoon. Fixed the CEL problem momentarily. I took it for a short test drive around the neighborhood. About halfway through it came back on again. I ran codes with a jumper wire in the test plugs and got a Code 11-all clear.Any ideas/suggestions?J

Hello all, Hopefully there is somebody out there still watching this forum. I finally had some time off to test my TPS. I tested the TPS voltage- 0.03v; getting power from PCM-5v and have good ground. TPS was installed brand new. Thinking I got a bad one. Gonna take it off and swap it out...

Hello all, Hopefully there is somebody out there still watching this forum. I finally had some time off to test my TPS. I tested the TPS voltage- 0.03v; getting power from PCM-5v and have good ground. TPS was installed brand new. Thinking I got a bad one. Gonna take it off and swap it out...

Any suggestions on where to start looking, what to start adjusting. The TPS and IAC Valve are brand new.

Take multimeter readings at the TPS? What is signal reference voltage (I can turn wrench but electrical is not my specialty)? How do I determine if signal is getting back to computer? Where is the computer located so I can check for corrosion? I will go and spend a few pennies on dielectric...

Any suggestions for how I can fix any of these problems.

Hello all,I have an issue with my truck that I am hoping you can help with. I have posted in forums like this before and not had very good luck.I have a 1991 F250, 5.8 L, 125,000 mi. I have owned the truck for about 8 months and would actually like to be able to drive it. I bought it with a...

Hello all,I have an issue with my truck that I am hoping you can help with. I have posted in forums like this before and not had very good luck.I have a 1991 F250, 5.8 L, 125,000 mi. I have owned the truck for about 8 months and would actually like to be able to drive it. I...