My issue is that it is rusted about off and I am looking for a replacement. I am trying to find out if one is available or if it is something that I need to fabricate.

I am replacing all the rotted parts on my 75/79 f100. There is one part in particular that I can't find. There is a mount for the front fender that is in front of the inner rocker panel that I can't seem to find. It is located under the front lower pillar and the lower rear portion of the front...

I am looking for some hinge pin kits for my 79 f100. I would rather not have to buy all new hinges. Anybody know what other ford vehicles use the same pins that might be available through dormans or such?

The bearings are marked 30. I figured the only problem could be they sent a bad crank but you think they would check it before they sent it out since they say they recondition the cranks. Also with the original 351m crankshaft my clearances were about the sameas the 400.

I am rebuilding the 351m that was in my 79 ford f100. I decided to turn it into a 400. I ordered a crankshaft from northern auto parts that is thirty under with bearings to match. When I plastigauged the mains I found that my clearances were between .002 and .003. Everywhere I look it says my...