I replaced the dual mass in my 350 with a LUK kit. After 16,000 miles the throwout bearing was squealing louder than the engine. After replacing EVERYTHING but the flywheel I found out there was nothing wrong with the bearing. There were several fingers on the pressure plate sitting higher than...
went to truck this morning, opened door and dome light full power, started up and drove to work like nothing happened. now if it will start this evening .....
charged batteries and took them to 2 other dealers who found nothing wrong,cleaned terminals, cables and checked all grounds and every wire i could find for damage and found nothing.swapped out 2 other batteries and still the same result
I did hit a deer 4 weeks ago on the driver side of the truck and 10 minutes later my headlights blinked several times and went out for several seconds.This has not occurred since then.I thought that maybe something had grounded out but found nothing when i replaced the turnsignal lens
That was my first intention.When I took the batteries to the local interstate dealer they tested good. They said that both were fine but they would sell me new ones if I wanted. Over the weekend I removed the battery in question and set it on top of the compressor so I could replace a turn...
batteries checked out ok, passenger side was a little low.
drivers side started fizzing,stinking and got hot after turning headlights on. found no stripped or exposed wires though
Tried To Start This Morning And Had Barely Enough Power For Interior Dome Light. Checked Batteries And Had 11.4 And 12.33 Volts.
Could A Cell In Battery Have Shorted ? Changed Turn Signal Lens And Injector Lines Over Weekend And Inspected All Wires In Vicinity So I Don't Believe I Have A Short...
for the past 4 years in the months of april and october i have to replace my injector o-rings. the fuel that leaks accumulates at the back of the manifold sloshes out when you hit the brakes. anyone else having this problem? could the o-rings be shrinking or deteriorating or could maybe the...
for the past 4 years in the months of april and october i have to replace my injector o-rings. the fuel that leaks accumulates at the back of the manifold sloshes out when you hit the brakes. anyone else having this problem? could the o-rings be shrinking or deteriorating or could maybe the...
entire truck is 95% as new, all original drivetrain (IDI turbo diesel) ,paint, exhaust,166,000 miles and body except for deer dented fender last week (being repaired now). used to get a new one every seven years and lost track of years this time.
12.50x25x16.5 BFG Mud Terrains with 5 new super...
thanks, mine sound like jingle bells now and are razor thin or worse in the bolt pattern
checked ebay for visor but no exact match
ford called and had shields NOS from a Salvage co. for $90 each
just priced a 2011 350 xlt 4x4 6.7 with sunroof , trlr pack, 6 speed auto and a couple of other options to replace my 94 350
sticker $60,295 and that wasnt with every option
$60,295 minus my trade of $3800?????
there was only one fool present at this offering and it wasnt me
just priced an equivalent replacement for the 94
no way i am going to spend $60,295 (the sticker price)
and they can kiss my obama before they will get my 350 for $3800
Thinking About Replacing My 94 F350
Do The New Trucks Have Repackable Front Hubs Or Are They Throwaways Like Gm?
2011's?Also Any Other Changes That Have Been Implemented Since My Last Purchase?I Was Told To Stay Away From 6.0's, And That 6.4's Drink Fuel
i asked the dealer about ordering the plastic tee's and their response was
" it is a dealer only part and has to be installed by one of their mechanics"
i am going to another dealer saturday as i believe that that comment was BS
94 7.3 turbo idithe manifold is filling up with fuel and then leaking all over the place. if i make a sharp turn, it empties all at once. i have replaced the o-rings several times and the injectors are fairly dry. i took it to a dealer 3 times as i thought it was something complex, and they...
i have now changed all tie rods in addition to pump and box and still have MOST of the problem. after turning full lock to either side, it feels like the hubs are locked as it wants to wobble even in a straight line. if you come to a complete stop and start out with the wheels straight it goes...