Hey, y'all –*I spend most of my time over on the Gen 6 board (since I have a '73 F250 and a '74 F350 SCS), but a good friend of mine has two '61 Unibodies.The first one he bought came with an airbag setup, later Ford front clip, etc., so he bought a second one to scavenge parts from. Both are...
I'm smellin' you on that, broseph. I'd love to have the kit...he1l, I'd love to have one of each of the few Dent kits that were actually made, but I just don't think they're worth that much. But maybe I'm the one smokin' crack...
My '73 F250 was in "Pursuit of Hapyness" with Will Smith and an ad for Cisco Systems, but I don't think the crew appreciated that thing firing up and idling with its straight pipes and dumps facing down right before the rear axle...blew dust and gravel all over the place every time I started it...
I always keep my eyes out for Dent model kits...and they seem kinda rare. But $90 for the Tuff Truk?!?!http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=120689096216&viewitem=&sspagename=ADME%3AB%3***%3AMOTORS%3A1123#ht_1923wt_1141
OK--that connector is the missing link I wasn't aware of! I'll get under her and take a look and see if I can find that thing.Now, as far as that tee connector goes, Mil1ion: I've never seen one quite like that ––*is there a shop near you that sells them? I'd love to get my hands on one of...
Ah, I think I spoke too soon: I don't have a tee like that at all. But that sure does look like what I need!So, Mil1ion, is that diagram showing a harness at the rear of the frame that was factory installed?
Thanks, Mil1ion –– I got the wiring running down the driver's side frame rail, but I don't know where to connect the wiring to actuate the turn signals, flashers, brake lights, etc. I bought the bundled wires that are all color coded and labeled, but where do each of those wires connect? Do I...
Question: what does a fan clutch actually do? I've got one on my '74 F350 SCS's 460, while my old '73 F250 w/460 didn't have one.What's the advantage to a fan clutch? I've always seen them, but never really knew what they actually did...
Hey, guys ––*I'm finally getting around to installing the new hitch receiver on my '74 F350 SCS. Got the receiver mounted and the brake installed and wired, as well as the hookup mounted at the rear.But, now I have to run the wire kit from the front of the truck to the rear and into the...
Got it all back together and I ordered a $12.00 pin from Dennis Carpenter (which was a H3LL of a lot cheaper than LMC's $40+ version). I manually held the switch and sure enough, she started right up.Do these things break when the steering shaft moves against the static pin? I'd heard of...