Ken - good catch on the flag. Definitely a general lee inspired build.
Pet pev of mine on these trucks is not matching the interior to the body color.
At least he didn't call it a HighBoy.
http://www.superbrightleds.com/cat/tail-brake-turn/filter/Cross_Reference_Number,1156,21,194:The link above is from SuperBriteLED.
I just did most of the bulbs in my 04 F150 and the wifes 06 Escape. Very happy with the results and SBL.
Best advise I can give for led lighting is you get what...
Another idea.
On the trim in the dent, the black plastic piece. Paint the top and or bottom with the width of your choice. Wouldn't be so obvious that it jumps out at you but subtle and would reflect off the aluminum a bit. A couple bucks on some pinstripe tape to try it on and easily removed if...
Got the motor pulled last week. Not alot of room to work but i got it done.Gained about two inches with the cowl removed.Left the radiator in. Have the disconnect tools but couldnt get the lines removed.Some thing else i didnt think about. with the arm extended all the way out at full...
Ended up ordering a crate motor. Should be here tomorrow. Decided against a used or remaned.Starting to take everything apart getting ready to pull the motor. As the oil is draining out I take a look at it a few minutes later and WOW! I scramble to get my other drain pan. The one I'm using...
Yeah that's still an option. Only thing is that price is creeping up there. And then I'd have a new top end and old bottom. May be better to have a remaned where everything is done and start fresh. Got some research to do. Figure out which direction to go.
Well...This is kinda disappointing. Three of the caps that hold the cam down on right side are cracked in half. The journals on the cam are scored real bad. Out of the 12 lash adjusters only two will move freely.