I'm still working on the speedo but I changed the sending unit and that solved that problem. In the meantime I'm going to use a gps to tell me my speed.

the guages are VDO . It's crazy because now the speedometer doesn't work. It's all electronic no cable. As far as the gas guage, I was trying to avoid taking out the sending unit until I know for sure if it is the guage or not. I guess that will be the way to find out though.

Okay, I have my truck running really good now , just tuned it up. I do however have a small problem, the gas guage. It always reads full, I checked the sending unit by taking off the wire and grounding it and it then goes to empty. There is only one wire on it so I assume the tank is grounded to...

the number I have is 97HC178351

Thanks Tim, I just got the windows yesterday and will attempt it this week. I have a model T friend who said he will give me a hand.

When i bought the truck (1949 F1 ) the drivers door window had a few little cracks in it. Now it has a large one going across the whole thing. I ordered new windows, seems you have to buy them in twos. Anyway can anyone give me info on how to remove and replace the window? I have the panel off...

I haven't really taken it out for a real test because of all the rain we have been having and I need to replace the cowl gasket because it leaks there badly. I actually got the weather stripping yesterday and will install it today.Today it's supposed to be dry so I'll take it out for sure. I did...

Jasperrc, you got it right on the money. the Idler arm was from Mitsubishi as well.

updateOkay I put in a new electric wiper motor ,horn and cigarette lighter to charge my phone. Replaced the Idler arm, one motor mount , front calibers and rear brakes and new drums. After a lot of investigation the front is out of a 1985 dodge truck and the back is a chevy rearend. Combined...

I just realized I put drivers door it's the passenger door if that matters

My 49 F1 has a pluged hole on the drivers side for a door lock. I took the panel off and tried to look inside , couldn't see much. The replacement locks I see that you can buy just show a straight bar. Is there more to this , it obviously isn't like a house door lock. And just how do you install...

Looking under the truck it has a rectangluar tubing frame no cross bars except trans and engine supports. The Isuzu and chevy trucks both used the same lug bolt patterns though.

Thanks no I don't mind. now to put a new gasket in for the cowl and the new wiper motor I ordered, Ac and it's good to go ! I hope to drive it everyday and enjoy it

I posted photos in the gallery of my 49. This truck supposedly came out of Tennesse, anyone ever seen it before ?