Thank you SuperCab! I am partal to the grey stuff too. I used it to seal the belt housing to my boat's mud motor that I designed.Sent from my HTC 10 using Tapatalk
I've been cranking the truck daily for the past week since I finished the steerong box install. I grab a few minutes here and there to try to dial in the tune because the vacuum gauge keeps hunting.. (intake gasket, sigh)Yesterday I drove to the gas station and of course, Murphy struck and...
To my dismay when I was dialing in my carb and timing with my vacuum gauge.. I realized that my intake manifold was blowing a few bubbles and blowing oil pretty badly.I've got the origional 80lb intake.What I need to know.. While I am in there, what else should I replace, check, adjust...
To my dismay, I discovered the intake manifold gasket is blowing oil pretty badly. About to create another post for advice on that one.. Look for it.Sent from my HTC 10 using Tapatalk
I am a little suspicious of my power steering pump as it is a little jerky... It is the only older part left and likely damaged due to previous gearbox leak. I will give it a little more time to see it it is a stubborn air pocket.Sent from my HTC 10 using Tapatalk
Well, I finally got back to the truck after being distracted by my boat...
Yesterday I finally hooked the power steering lines to the transmission cooler in the radiator and the gearbox. I bled most of the air by last night and this evening I will do some more. It was great to finally drive it...