I have had timming chains jump before and break before! I have had valve springs break while running! Also have had a head crack between two cylinders while running !I would say check the timming to make sure it is correct first, then maybe check your cap to make sure it didn't crack,then...
I have a stock 400m 2 barrel in my 78 f250 with c6! Not sure on the hp but it does ok , I did find a fuel injected 92 460 that I may try to increase my mpg! my last check was 6.4 mpg UG!! no smoke no smell , thinking i blew the power valve again... Does the c6 bolt pattern stay the same for...
Thanks ! For now i think i will locate a 130amp and see what that gets me! This thing will have quite a bit going out with all the lights and stuff, also have a small generartor and a small solar panel on the roof! Now if the weather would cooperate i could get some of the stuff done!I did...
I am starting to integrate the camper to the truck electrical system ! I think stock alternator is around 60 amps! Any advice on how big i need , i have 3 batteries! I am not even sure what is available!? looks like fun at any rate!! I just put in another battery tray on the drivers side,and...
I have to agree with Bucks 77ford ! start with the basics and make sure there is spark and move from there. My 78 250 wtih 400m had the pickup coil in the distributer go out on me in kindof the same fassion! was doing something else ,oil pump froze and twisted the pump shaft off, replaced the...
Father Doug ! thanks that is one i will try if I totally mess up what I just started! I was trying to save some money, that kit does it cheap enough! Thanks again Dale
My pictures finally loaded, they were somehow not supported in the files so i had to resave them in my system before they would upload! thanks for all the advise!I find it interesting that companies sell the f150 sway bar parts but not the 250 ! Grr I did find some on ebay that look right ,so...
Finally loaded some photos!!!
I found a used rear swaybar for my 78 f250 ! now i need the drop /end links for it! 2 of them ! I tried to remove the the links from the sway bar and replace the bushings and the bottoms broke off ! I need to find the links ! Any ideas , I have tried LMC...