- Moderator
- #21
Lol. I still want that ranger edsel BAD.
Owmbo looked it over today. Said. " it needs an awful lot of work"
Btw Jon, it's the 410 in there, and it's still mostly all there......
Sent from my SM-N960U using Tapatalk
I always hated doing those. I had one that always leaked, sometimes it would dump everything, sometimes just a small leak. I went after it 1 day and instead of doing like you are there I pulled the whole thing out and found the bottom brackets at the front that bolt up to the oil pan were missing and broken. No more leak after that. IIRC it was in a 627F scraper, but could have been a 637 also[emoji848]
That sounds like a controller???Here's a question for use guys......anybody know anything about swapping out a DDEC 1 to a DDEC 2?
Here's a question for use guys......anybody know anything about swapping out a DDEC 1 to a DDEC 2?
That sounds like a controller???
Depends on if the inputs to the ecm are the same. I’m not sure if you can upgrade to the better processor....
Sent from my iPhone using Tapatalk
What are or were they in I can pull a schematic
DD changed the firing order that’s why the cams are different. I believe the cam / firing order change was in the DDEC4 family but I might be wrong . I believe you can upgrade easily but be warned the DDEC2 is very very sensitive to voltage spikes .
If you changed cams then went to DDEC5 you could run 24 volts to it ....
Sent from my iPhone using Tapatalk
Why what are you doing[emoji7][emoji7][emoji7][emoji7]I hear som butt kissing noises
[emoji12][emoji23][emoji23][emoji23][emoji23]
Sent from my SM-N960U using Tapatalk