Kaajot
Micro Machine Manager
The 6.0 Update Fix
Hi all-
We put the new ECM in -- it now runs just fine, although there is a check engine light still and we cannot get the KOER to run. It pauses after initial setup and says "Cannot detect Injector" or something like that. I did not take a picture of the print out.
It does not even start going through different rpms or get to pumping the break, steering the wheel, etc. It literally cannot detect something and hangs there.
Could this have something to do with calibrating the EEC-IV?
As stated, it's running pretty well so far. I'd dare say it's running almost as good as when I first picked it up.
Also, the old ECM did have a busted capacitor. So that was the correct diagnosis. The TPS, IAC, Coolant Temp IAT, etc are all reading correctly now.
Ideas about how to fix so we can pull the remaining engine codes from KOER?
Hi all-
We put the new ECM in -- it now runs just fine, although there is a check engine light still and we cannot get the KOER to run. It pauses after initial setup and says "Cannot detect Injector" or something like that. I did not take a picture of the print out.
It does not even start going through different rpms or get to pumping the break, steering the wheel, etc. It literally cannot detect something and hangs there.
Could this have something to do with calibrating the EEC-IV?
As stated, it's running pretty well so far. I'd dare say it's running almost as good as when I first picked it up.
Also, the old ECM did have a busted capacitor. So that was the correct diagnosis. The TPS, IAC, Coolant Temp IAT, etc are all reading correctly now.
Ideas about how to fix so we can pull the remaining engine codes from KOER?