Ford Truck Fanatics

Ford Truck Fanatics (
-   Generation 6 (
-   -   Question on aftermarket rims (

dexleo2 04-28-2017 03:18 PM

Question on aftermarket rims
Hello all again its me and I have another question for you all. I need to put new rims and tires on my truck. I have the tires already and was looking for a cheap rim to put the tires on that will fit my truck. So i was interested in these: but when I go to the link that is in the question and answer section to make sure they fit my truck it tells me these are not compatible with my truck anyone know why that is?

LEB Ben 04-28-2017 03:49 PM

It's the correct bolt pattern...only potential issue would be hub centric vs lug centric wheels, but I don't see that listed.

cbaker65 04-28-2017 08:52 PM

+ 1 what Ben says ,make sure the center hub section is the big pattern ,
which newer ford hubs are smaller!...Nice rims!....YelloThumbUp

fatherdoug 04-29-2017 06:07 AM

Would the offset or backspacing make a difference?

Fellro 04-29-2017 11:50 AM

Center bore is 4.28. Factory center is about 3 7/16" so may be why they say that. Unless you haul heavy, you can use just lugs to carry the load. Just make sure they stay tight

dexleo2 04-30-2017 03:36 PM

Thanks for all the replies everyone thank you

Fellro 04-30-2017 11:15 PM

It is pretty hard to find aftermarket rims that do the hub centric. Run many over the years that did not have the center support and survived fine.

Sparky83 05-01-2017 12:29 AM

if need be you can buy centric ring spacers to make up the difference... i did that with my old truck.. only time it became a problem was when the brakes needed done.. would have been another problem whenever i would have needed to use the spare.. but never had to..

All times are GMT -5. The time now is 10:36 PM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Ford Truck Fanatics is not affiliated with or endorsed by Ford Motor Company.