Darn crap! Beet juice is the way to go but the cost is what keeps us from using it. Even with all the environmental awareness they still keep using the toxic cheap stuff!

I feel your pain - the pretreatment they put down is the same calcium chloride used for ballast in tractor tires - it will destroy rims around the valve stem, after it east out said valve stem. Actually had that happen on an old Ford 2N just...

This was heartbreaking :cry:

SMOKEY! Good to see you bud 😄 And yes good memory -- there was one trip up to Tahoe where I must have been shortly behind the truck laying down salt because 1 single trip turned my whole undercarriage orange and I was irate 😂 Thats when I learned...

The frame pedestal. You will need the bell housing too if both are manuals. Nothing from the FE works with the 300.

Welcome to FTF! smilieFordlogo

Hi from central Illinois, wife has a 69 f100 2wd 360 with a C6. Decent enough old truck, pulled engine to seal it and trans up. Jeff

Welcome to FTF! smilieFordlogo

This thread is for the truck profile titled "1977 ford f150 ranger xlt". Click the Watch button to get updates and comment on it below.

Thank you so much for giving me these two ideas I went to both of their websites looked around like what I saw a lot requested catalogues thank you and I will also move over to Facebook. Have a great week.

I've been a BAD boy!

Nice! Welcome to FTF! smilieFordlogo

I have the hood and tailgate painted and going to primer it next week