Thank you SuperCab! I am partal to the grey stuff too. I used it to seal the belt housing to my boat's mud motor that I designed.Sent from my HTC 10 using Tapatalk
I've been cranking the truck daily for the past week since I finished the steerong box install. I grab a few minutes here and there to try to dial in the tune because the vacuum gauge keeps hunting.. (intake gasket, sigh)Yesterday I drove to the gas station and of course, Murphy struck and...
To my dismay when I was dialing in my carb and timing with my vacuum gauge.. I realized that my intake manifold was blowing a few bubbles and blowing oil pretty badly.I've got the origional 80lb intake.What I need to know.. While I am in there, what else should I replace, check, adjust...
To my dismay, I discovered the intake manifold gasket is blowing oil pretty badly. About to create another post for advice on that one.. Look for it.Sent from my HTC 10 using Tapatalk
I am a little suspicious of my power steering pump as it is a little jerky... It is the only older part left and likely damaged due to previous gearbox leak. I will give it a little more time to see it it is a stubborn air pocket.Sent from my HTC 10 using Tapatalk
Well, I finally got back to the truck after being distracted by my boat...
Yesterday I finally hooked the power steering lines to the transmission cooler in the radiator and the gearbox. I bled most of the air by last night and this evening I will do some more. It was great to finally drive it...
On a side note.... Here is another project I just tackled that you guys will likely get a kick out of...Duck hunting boat to jet bass boat conversion....https://goo.gl/photos/BpJvdnUuc6axMUNf6Sent from my HTC 10 using Tapatalk
If you guys remember, I intend to make a 3 phase spring resistance throttle... Little resistance... Granny gear, medium resistance... Fuel economy, and cruising speed (around 70 mph on flat) final heavier resistance... Gettin on it, passing, and playing! Anyway, the hook bends are to be...
Mine is a 4x2 and this is probably not helpful but just in case... This is mine... I got it from o reilleys for a reasobable price. 130 - 150 if memory serves. Mine is power.Sent from my HTC 10 using Tapatalk
Yup! Btw, Ive got some Bakers in my family! My aunt married one and popped out a couple ford lovers that have a decade on me.Sent from my HTC 10 using Tapatalk
It will have purple plug wires, lines, and hose dressing, the distributor cap will be yellow, and the coil pack on top will be black. Of co7rse those changes will be made as needed or last, which ever comes first.Sent from my HTC 10 using Tapatalk
Steering gearbox mounted snugly to the frame... Pittman arm poked and coupler lined. Just need to tighten the connecting hardware. I'm thinking those might have been the 3 most difficult frame bolts with which iv'e dealt!Sent from my HTC 10 using Tapatalk