And its easy just cut the pipe just before the 2nd cat where the pipe is 3" and run a straight 3" pipe wherever u desire to route it.. i will take a vid this afternoon for u guysI swear i think im driving a cummins lol
It will not start on the first try but right away on the 2nd try in the morning and like when i get off work also it wont but when driving stop and shut it down for a few mins its fineThe fuel pump is wired seperatly and i even let it run for like 10 seconds nothing..I was thinking chek...
Does these trucks has some kind of safe mode? Like it wont go more than 10% load so it dont burn the trans up??These are the codes i got637 tot sensor was high
327
654mlps sensor not in park
558 egr valve
621 shift selenoid 1 open
629 tc clutch selenoid failure
627 tc selenoid failure...
A real headschtratcher for u guys.. my new obs 1994 bronco 5.8 4x4 e4od runs and drives great but has a few electical gremlins.. when u switch the headlights on the rpms drops dead and has no dash lighting.. and somethimes it idle hunts in neutral.. and somethime the engine idles like around...
Need a little help.. I have an f250 1997 powerstroke automatic bad engine and trans and I have an 1988 f150 inline six 5 speed. in good running condition.. what is neccesary to swap the engine and trans from the f150 into the 1997 f250? Engine mounts from the f150 harnass and ecu.. and full fuel...
finally got the motor running no missfire the carb was bad borrowed an 850 and ran good but still a prosystem race carb is on its way nway here are resultshttp://youtu.be/jPgphsVjGXY 1st and 3rd pass (brake out) but i didnt mind i was looking for the best time not to win...
its a 1988 F150 4.9 5 speed and im only getting 11.5 mpgswhere are the best ways to start to get more? if i get 14-15 im happy!where to start?? ive gone soo deep into the carb world i forgot the basics about these trucks
had a edge mild street in the truck wich is basicly a modded stock converter.. drove it for a while give it a good run shifted 2nd a few times at WOT after the 3rd time one it stripped the converter input slinesi borrowed a stock converter and tuned the engine rejeted the carb / timing/...
it started to do the it wont start when warm thing and ids showed 350 psi at cranking then after a few days showed only 150 psi of oil.pressure but it does start with baygon lol yes we start it with baygon but now its got worse it wont start even when.cold anymore we start it with baygon...
As the title says this explorer when coming to a e stop at a traffic light or a corner only when stopping ful.it stalls but it only does.it sometimes not allot what could.it be??
changed flasher but still nothingwhen the flasher is bad does the turn indicators on the dash work ??mine does nothing! no indicator on dash or nothing! is there a fuse? i dont have the fuse box diagram anymore thats whyor is the thing on the column bad??thanks!
got a good deal on
2 12" 80W fans ( i think they flow about 1500 cfm each no idea does any one know?? how much 12' fans 80w flows?here is a few picsjust happend to found a perfect piece of stainles in the back yard and perfect size
it was a door to something lol! 'smiliepig3'27x17...
been a while since ive posted... hows everyone?? i see some of u guys on FB where is 'smiliepig3' ?havent done much on the truck been busy with shool and internship etcgot the 2 trucks together for a photoshoot and wanted to share... :)just a Few teasers.. ill post some...
60 ft is bad... with slicks no spinning... see in this vid and hear how it launches
the stall is only 2200 rpm its very low for this engine i think a 3000 would be perfect!96D8g6wxX0Y
2005 6.0 when start / cold it starts great but it has no power and blows white smoke until it gets up to running temp after that it runs great. any suggestions what it could be??
Just changed all 8 injectors and harnas and cheked the ficm all the fuel filters oil and everything. When we try to...
on Aruba there is 3 raptors 1 black 5.4
one white 6.2
and one silver 6.2i was chilling for a friday night drive and the Silver pulled up next to me and did a rev.. i was like well i will give it a Tryhahaha the guy almost went back and traded the truck back in blast away and left him for...
all the little details that count that make a vehicle look 10 times better...and i promise it will be the last thread with my pics haha :P sorry the truck never looked this good... and they say a Gen 8 wont look good lowered... on top of that its a longbed!!
bored..beforeAfterNEver ever give up! nomather how tough the going gets.. ive got so frustrated a few times i even hit the old rusted bed with a hammer lol.. the bed was gonna get replaced so i had my fun with a hammer on it!just wanna be inspirational for a few of you who got...
going to pass inspection soonthe brakes pads in the front are new the wheel cylinders in the rear are new with good brake shoes.. now when testing the brakes today ive noticed the truck pulls a little bit to the right but only when mashing the pedal really hard and skids.. doesnt pull when...
bored and i decided to cut the coil springs to lower the truck and see what happens.. if i dont like it i have a set of spare stock coil springs i can swap anytime..i think it just needs alignment and done :Di can match the rear by removing leafspringswhat do u guys think??
my inspiration to finish my god forsaken school!!!!!!i have to do a school presentation about superchargers so my good friend borrowed me his baby..note: im gonna buy it when i finish school..
it has about 500 HP 550 ftlbs of torqueand chek this outLOW MILES!!!!!!
A/C
pristine...
testing dads new camara and letting you guys hear how it sounds whenthe cut outs are closedjust finished fine tuned the carb thats why the filter is of
nice quick throttle response!!!POmg6a2YL4wthe tires and drums are off because im repairing the axle ;)
did a burnout at moms wedding lastweek and at the corner the diff locked!!!! i had to reverse to get it to unlock..then....atleast the ring and pinion are ok!!! thank god20 years of working and last few years of dragracing and performance it didnt like it that well
The police tow truck has been running great since we changed the ipr and harnass but now it started to smoke (blue) out of the exhuast. What will cause this??
ive just learned that a 4r70W from a 4.2V6 truck will fit mine.. and my c4 is giving me all kinds of problem.. the Trans is down again if i get it back in and its not working i will sell it for parts..and i wanted to ask..
becuase the parts truck (2000 4.2V6 F150) we have has an perfectly good...
I'm gonna swap 4.10, gears from a mustang in my trucks rear axle and my 3.55 in the mustang is it a direct swap are the splines the same? Its a 1991 foxbody.