First the truck is running just fine.The other day while I was driving to work my low fuel light and bell came on and fuel gauge was on the low stop ( below empty).
The tank was full, just fill it. 46 gal tank. A few minutes later the light goes out and the gauge is back at full. So the...
Got the truck back today. 73 mile test ride ran great. Dave is the Man.
Daves Garage LLC Canterbury CT. New head gasket, EBP sensor, 2 New Exhaust Manifold w gasket, New water pump, Oil cooler 2 New injector for cyl 1 & 7, Upgrade to Studs, Dipstick tube, Glow Plug Harness and New Transmission...
Blue Goose There is 185 k on her.
Sparky83 It's over my head what happen. watch it be something simple like a bad EBP. I just work on the thermostat and had to move it.
let know what happens.
I little more info. Was in panic mode. As i was pressing the throttle my Boost when high 30+ and ECT when to 234 and EOT to 215.
So thinking that the turbo when bad and over boost, possible lifting the head causing the lost coolant. My Mechanic will be back on Morning, going to be a long weekend.
This morning I had a problem with the truck has I was getting on the parkway for home I press on the pedal and noting no power and then lots of power,
I as I got to the top of the hill it seam to got better but started to over heat. So I slow down and all seam to go back to normal. I look up...
Ok it was the Thermostat got it change out . test, it opens at a lower temp.
now to replaced the clamp that haled the fuel line. lost it somewhere.
Thanks blacksnapon.
I Did an Coolant flush and use restore and vc-9 and changing to red coolant, I couldn't get out the Thermostat because of the return fuel. I could not get it lose. So I did a 3 day 21 gallon distill water flush. This morning the coolant temp on my Scangage is read 166 to 170 ECT and EOT...
So 9 years ago I installed a Transfer flow 46 gal fuel tank, I like it but the paint has fallen off and the tank is showing rust. I thought I pull it off and paint it, well let say it was not as easy to pull and it was to install.
I started with Hand tools move to air tools and lastly the Saw...