Join Our Ford Truck Forum Today

Document your Ford truck project here and inspire others! Login/Register to view the site with fewer ads.

Kaajot's latest activity

  • Kaajot
    Yeah, I figured one of my multimeters will have that (I have solar-installation grade electronic equipment, but am not ever doing diagnostics on diodes in general). I'll figure that part out, something about a resistance check on current should...
  • Kaajot
    My one test light on me was corroded on the inside, so couldn't do much. Did pull the PCM Power Relay Diode (nomenclature, found) F2TF-14A604-AA part #. Apparently hard to find if it goes bad.Unsure how to test it yet, as power should only...
  • Kaajot
    Another Question: Could I have sprayed something on the frame rail with PB Blaster that shorted part of the fuel pump wires, etc?I was underneath PB and Penetrating Oil on multiple bolts that I plan on knocking out now or later (removing...
  • Kaajot
    Looks like all system components between my 91 f250, 92 f150, and 97 f350 are interchangeable, so I have relays, fuel selector switches, etc to swap and try. Unsure about the PCM/ECM Relay/Fuse. Going to look at in the 3 vehicles and see if a...
  • Kaajot
    That didn't take long. I am lucky if I have 10 miles on this thing since purchase in August. That's a whole different story on why I wasn't driving it and will be settled in a court, but that's not the problem.So the rear tank doesn't fill...
  • Kaajot
    Kaajot replied to the thread 1997 F-350 Longbed 7.5L.
    Ok, last thing. The front gas tank (new tank and filler tube installed) takes gas. The Rear aft of the rear axle (not mid-ship tank!) will not take gas and shoots it back out at the new filler tube. It looks pinched, but the tank looks a...
    • Aft Rear Axle Gas Tank.jpg
    • Installed Filler Tube.jpg
    • Old Hitch Supports.jpg
  • Kaajot
    Kaajot replied to the thread 1997 F-350 Longbed 7.5L.
    Have some leaks from oil pan, back.Think it's the oil dip stick mounting point and the drain pan needing a new gasket on its drain plug. Adding pictures for that and wondering if the transfer/tranny look like they're leaking too, or is this...
    • PB Blasted Oil Check Tube.jpg
    • Slight Fluid Leaks.jpg
    • Slight Fuel Leaks 2.jpg
  • Kaajot
    Kaajot replied to the thread 1997 F-350 Longbed 7.5L.
    Ok, next update question/scenario:The Cat Converter is rough and muffler/tail pipes are non-existent. Needs a new muffler/tail pipe and hangars at the minimum? There is ONE ok-looking hangar, but this muffler should be a dual-exhaust at least...
    • Top of Catalytic Converter.jpg
    • Rear Hangar.jpg
    • Catalytic Converter.jpg
    • Broke Structure Supports (Cat Con verter).jpg
    • Aft Structure Support to Bed.jpg
    • Aft Structure Support Driver Side.jpg
  • Kaajot
    Kaajot replied to the thread 1997 F-350 Longbed 7.5L.
    Ok, so here are some pictures of the F-350 with a leaky dip stick tube. I took a look at what I was sold on Amazon and it is shorter and looks questionable. Truck's cab is clean, the frame is pretty good despite lots of rust from the bed and...
    • Brake Control.jpg
    • PB Blasted Oil Check Tube.jpg
    • Right Side.jpg
    • Rear.jpg
    • Left Side.jpg
    • Front.jpg
    • Cab 1.jpg
  • Kaajot
    I'm very interested in the e-crate on my 92 f-150. It's about a 50% increase in power and if gas goes to $5, well, I build solar power charging units so my gas locally will be cheap.They sold out of the e-crates allegedly already. That's...
  • Kaajot
    Thanks Dusty! Wish I'd snipped it once I made some space (less stress on the fuel line to extract the remainder I reckon, eh?). Hopefully a new clip inserted will grab and hold. It's currently just held in place by pressure and working, but...
  • Kaajot
    Seconded on that. Bronco is located in Michigan too IIRC, which is where I'm from. They're near my home town area -- support them, they have good stuff!Have bought from LMC, they're ok. Heard of Dennis Carpenter, unsure if I've ordered...
  • Kaajot
    That's sad.If I've destroyed the internal fuel line due to all my prying, what's the best fix? Snip and add some kind of after-market clamp? Rubber fuel line inserted into metal fuel line hose and then compressed via a clamp on fuel filter...
  • Kaajot
    Called NAPA last week, they have one type (link) I haven't seen it in 3D, but I'm guessing this is a plastic clip that goes past the fat end of the fuel line and then pulls against the nipple on the fuel filter nozzle, preventing it from pulling...
  • Kaajot
    Kaajot replied to the thread Might have found me a bumpside!.
    That's neat.Is this the first "Custom" series? I have a '92 F-150 Custom, didn't know it went back further.
Top