Sounds great, but I am new to HEI, and my old Ford wires do not fit the cap. Which wires would you recommend? What would they fit? Part number? Thank you, F O T
It was new one on me too! I could not get it to run right and it was spitting back through the carb a lot. It was also backfiring under deceleration going down hills. So I waited until dark, started the engine and the fireworks began. Blue sparks at the plugs and where the wires came in contact...
where the spark plug cap slides down and snaps onto the spark plug, there are arcs, mostly on the passenger side, cyl,1 2 3 4. I did not even think it was possible.
I also have an edelbrock 4v on the engine. The new Accel wires are arcing at the spark plugs, and arcing across the other plug wires as well.Unrelated the dist is binding up against the temp sending unit.Did I get a set of bad wires? The engine grounds are all there and seem fine.
Got it, thanks, tech still having issues.Someone cut off the plug to the switch and just wired the wires to the switch. Tech says there is only one hot wire on the fuse block. He says there is no way to tell where all the wires go. I am going to the shop Saturday to talk to him.Anything you...
I cannot believe not even one reply. I figured it out with help from the FEForums, the previous owner put a 2.75/1 3rd member in it, and the ring gear is a lot wider than the original ring gear, causing the axle to hit, therefore pushing the axle out as I drove. The idiot mechanic tightened the...