steering box question.

[cflcoltfan]

I have a 1979 f-150 4x4 with a 302 cid V8 engine. I bought this truck from another gentleman who had disassembled the truck for a future off frame restoration. The frame was a rolling chassis without an engine and transmission.
the question I have, the power steering hose connection ports on this steering box are pointed down toward the ground. This makes the running of the hoses somewhat awkward. Question is, can this be correct, would this inhibit getting the air out of system? Can this part of the steering box be installed wrong after being rebuilt? In other words, can the 4 bolts be removed and simply rotate the input shaft housing 90 degrees and reattach hoses? The reason for the question is I have never seen in all the photos on line, a box with lines going anywhere but upward. Thanks for your help in advance.

[BKW]

Originally Posted by cflcoltfan

I have a 1979 f-150 4x4 with a 302 cid V8 engine. I bought this truck from another gentleman who had disassembled the truck for a future off frame restoration. The frame was a rolling chassis without an engine and transmission.

Engine has been swapped. No 302's with 4WD until 1980.

What engine did this F150 come with originally? Is this a Regular or Super Cab?

Warranty Plate riveted to the left door face below the latch.

Post the Warranty Number (VIN).

[cflcoltfan]

Yes. I installed the 302 I had built for another truck. The existing engine was torn up. It was a 351M with a 4spMT. I went out and purchased a small block bell housing to mate the two. The vin # F14HUDJ1923 It is a regular cab.

[Fellro]

Looking at the parts photos from parts sites, they do point downward like that.I can try to go get a look at the 78 F150 4x4 I have and get some pics maybe.

[dustybumpers]

That is the correct box

Getting the air out of the system is done by turning the wheels back and forth, while the pump is being driven. It bleeds itself.

[cflcoltfan]

Thanks guys, you have been very helpful. Have to get back to the body work.

[BKW]

Originally Posted by cflcoltfan

Yes. I installed the 302 I had built for another truck. The existing engine was torn up. It was a 351M with a 4spMT. I went out and purchased a small block bell housing to mate the two.

VIN: F14HUDJ1923

F14 = F150 Regular Cab 4WD Pickup.

H = 351M

U = Louisville KY Assembly Plant.

DJ1923 = 1979.