hey guys had my truck out day testing out the brake system rebuild, new drive lines and does some leak checks. the truck was running fine had 50 psi of oil pressure are 2000rpm. i started to wind her out in 4th to make sure the rear drive line was balanced (shop build the front one long and out of balance). any ways after that my mechanical oil pressure gauge showed the oil pressure drop to 30 psi every time i put a load on the engine (even the slights load). let of the throttle and the oil pressure (at the same rpm) would go back up.
i got this 429 of craigslist last year it had about 50,000 miles on it. tore it all the way down and re bearing-ed it along with arp hardware and reused the pistons and rings.
ideas. am i looking over something simple? im thinking cracked crankshaft. mains and rods have less then 250 miles on them.
i got this 429 of craigslist last year it had about 50,000 miles on it. tore it all the way down and re bearing-ed it along with arp hardware and reused the pistons and rings.
ideas. am i looking over something simple? im thinking cracked crankshaft. mains and rods have less then 250 miles on them.