Hello........ anyone home???????

[dustybumpers]

Not too hard to carve a new body from pink or green foam from Home depot
I have that piece in the shed. Just a matter of getting to it. do you neew wheel all the way up? Arm? collar?

[dustybumpers]

Sparky needs to get one of my electric go fast cars to learn on.........

[cbaker65]

Originally Posted by dustybumpers

Sparky needs to get one of my electric go fast cars to learn on.........

I built one ,but I wrecked it ,stupid me , I built it an used a o-way diff spool
up front in which canceled out the front brakes causing a high speed out
of control when I used the brakes ,it slid an hit a parked car at full speed.

It hit so hard that it destroyed the ESC!...

[cbaker65]

The E-Ld3 test run after installing 3"s Lipo & gear change ,sadly I wrecked
it before going any further on raising higher speeds!

Heres a vid of the run.
https://youtu.be/Sthlwsapj44

An pics after the wreck.

[dustybumpers]

OUCH!
I did that first time out too with a similar set up
Very hurtful on the pocket book

Last one I built, I used a 1/6 grave digger body from a new bright toy
Left The sound in it. was pretty funny till I whacked the throttle. did wheel stands for 50'

[Sparky83]

Originally Posted by dustybumpers

Not too hard to carve a new body from pink or green foam from Home depot
I have that piece in the shed. Just a matter of getting to it. do you neew wheel all the way up? Arm? collar?

if that part was for me.. its just the little arm/collar combo piece i need to replace to get back to flight attempts... i dont know if that aluminum t25 one cb posted earlier would actually work or not.. when i was looking at the specs on them things before they seemed alot bigger than what was in it...

[cbaker65]

Originally Posted by Sparky83

if that part was for me.. its just the little arm/collar combo piece i need to replace to get back to flight attempts... i dont know if that aluminum t25 one cb posted earlier would actually work or not.. when i was looking at the specs on them things before they seemed alot bigger than what was in it...

That horn that I showed was for a servo ,that was before I knew what you need!

You will need a nose gear horn ,which dustybumpers mentioned to check Dubro's products earlier in the thread.
Dubro is a leading company that makes aircraft hardware ,an they have
those nose gear horns in any size!

You will need to know the size of the nose gear you have ,weather it
be 4mm ,5mm or 1/16 or 1/8 size!....

[dustybumpers]

That looks like 5 mm........ Best to put a measure stick on it
I think he has one of those fancy micrometer mojamy ones......

[cbaker65]

Originally Posted by dustybumpers

That looks like 5 mm........ Best to put a measure stick on it
I think he has one of those fancy micrometer mojamy ones......

.......

[Sparky83]

the inside of the collar converted from in to mm came to just shy of 2mm.. was like 1.9775