Join Our Ford Truck Forum Today

Document your Ford truck project here and inspire others! Login/Register to view the site with fewer ads.

DNFXDLI's 79 F150 Build Part 2

DNFXDLI

The Token Canadian
Staff member
Pretty much got the underside of the front crossmember area all done. The place where the steering damper was attached was somewhat fekked up probably from tagging stuff over the years.

I put some heat on it and used a wrist pin and 2lb hammer to flatten the high spot and then welded a couple of nuts on to the low spot and used a slide hammer to pull it up.

I'm pretty happy with the results.

20170415_150032.jpg


20170415_150035.jpg


20170415_150516.jpg


20170415_151009.jpg


20170415_152107.jpg


20170415_153618.jpg



20170415_160403.jpg


20170415_160713.jpg


20170415_160719.jpg


20170415_161455.jpg


20170415_161459.jpg


20170415_174443.jpg
 

DNFXDLI

The Token Canadian
Staff member

DNFXDLI

The Token Canadian
Staff member
lol and thanks CB
I ordered a set of carbide burrs to do the holes, sanding drum was pissing me off
 

DNFXDLI

The Token Canadian
Staff member
Surprisingly, the truck is pretty much the same now.
 

DNFXDLI

The Token Canadian
Staff member

Ford Truck Articles

Top