Shocks installed, I had to provide my own decal since Monroe did not provide them and when I contacted them I was ignored. Going to try to contact them again.
This is what holds the top of the spring or at least helps hold it. The other side was broke in half so I welded it together the passenger side (shown) is missing a piece so I can't do the same and I had already put back the drivers side so I...
New Monroe shocks, new rear brake lines and new diff vent hose with cap. Also drilled an tapped a hole in the diff in order to change fluid easier while I changed the fluid.
All new heater and radiator hoses, did some detailing, new battery cables, painted the air cleaner and put on a 360CID decal since everyone thinks it is a 351.
Started cleaning up the engine bay and tackled the rusted out battery tray. As a fix someone in the past welded a steel plate in the tray. Problem with that is you can't get to the two bolts under it. Had to grind off the welds to remove it...
Welp! At it again for parts. Hopefully tomorrow I will have a set of side mirrors with the turn signals.
Found a parts Lariat that has them. Should be just plug and play setup.